Diagnosis & Repair

WARNING: This page is about a different car, the 2003 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Using Toyota hand-held tester or scan tool, read FREEZE FRAME data. Freeze frame data records engine conditions when malfunction is detected.

For diagnosis and repair procedure, see Fig 1-Fig 5 . For A/F sensor circuit wiring diagram, see Fig 6. To check heater resistance on A/F sensor, see Figure.

When instructed to "Perform Confirmation Driving Pattern", go to TEST DRIVE CONFIRMATION procedure.

When access to, or replacement of ECM is necessary, Engine Control Module (ECM) is located behind glove box. See Figure. For ECM connector terminal view, see Figure.

For vacuum or EVAP hose routing, see VACUUM DIAGRAMS article. For testing of systems or components, see BASIC DIAGNOSTIC PROCEDURES - 4-CYL article or SYSTEM & COMPONENT TESTING - 4-CYLINDER article. For removal and installation of components, see REMOVAL, OVERHAUL & INSTALLATION - 4-CYLINDER article.

Fig 1: DTCs P1130 & P1150 Diagnostic Procedure (Steps 1-3)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: DTCs P1130 & P1150 Diagnostic Procedure (Step 3 Cont.)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 3: DTCs P1130 & P1150 Diagnostic Procedure (Steps 4-8)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 4: DTCs P1130 & P1150 Diagnostic Procedure (Steps 9-13)

Fig 5: DTCs P1130 & P1150 Diagnostic Procedure (Steps 14-19)

Fig 6: A/F Sensor Circuit Wiring Diagram