Power Window Control System: Initialization

INITIALIZE POWER WINDOW REGULATOR MOTOR
NOTE: If the jam protection function does not function properly, perform the following procedures.
1. Ignition switch on (IG).
2. (Power window can be partially or fully open.)
3. Close the power window by holding the Auto UP knob ON.
4. Continue to hold the Auto UP knob ON a minimum of 1 second after the power window completely closes.
5. Release the Auto UP knob.
  HINT:
  
  Front passenger must be initialized from actual multiplex network switch assembly. After initialization operation (from the multiplex network master switch assembly to the multiplex network switch assembly) will be allowed.