Repair Instruction: Initialization
WARNING: This page is about a different car, the 2006 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When disconnecting the negative (-) battery terminal, initialize the following system(s) after the terminal is reconnected.
SYSTEM REFERENCE CHART
| System Name | See Step No. |
|---|---|
| Power Window Control System | 1 |
| Sliding Rood System | 1 |
- INITIALIZE FRONT POWER SEAT CONTROL SYSTEM
- The power seat ECU must be initialized under any of the following conditions.
- The battery is disconnected.
- The D/C CUT fuse is replaced.
- The power seat switch (power seat ECU) is replaced.
- The power seat assembly is removed from the vehicle.
- Initialize the power seat ECU as follows.
- Using the seat switches, fully slide the seat forward, fully recline the seatback forward, and fully raise the seat cushion and headrest.
- Using the seat switches, fully slide the seat rearward, fully recline the seatback rearward, and fully lower the seat cushion and headrest.
- The power seat ECU must be initialized under any of the following conditions.