October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
On-Vehicle Inspection
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE EFI RELAY
- Remove the relay block cover upper.
- Remove the EFI relay.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- INSPECT EFI RELAY
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard resistance
STANDARD RESISTANCE SPECIFICATIONS
| Tester Connection |
Specified Condition |
| 3 - 5 |
10 kΩ or higher |
| Below 1 Ω (Battery voltage applied to terminals 1 and 2) |
If the result is not as specified, replace the EFI relay.
- INSTALL EFI RELAY
- Install the EFI relay.
- Install the relay block cover upper.
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)