Install The Battery

Lay the remote control on a towel or other soft material.
Place it with the back side facing up.

Fig 1: Identifying Remote Control Back Side
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Using a coin, pry open the remote control.
Use gentle pressure to avoid deforming the plastic.

Fig 2: Prying Remote Control Back Cover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Set the back cover aside.

Fig 3: Removing Remote Control Back Cover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Remove the rubber gasket and set it aside.

Fig 4: Removing Rubber Gasket
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Push the battery down and toward you, and hold it down.
Pry the back edge of the battery up and toward you.

Fig 5: Removing Battery
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Hold the battery with the plus side up.
Handle the battery with a cloth or tissue; body oils and moisture can interfere with operation and may reduce the life of the battery.

Fig 1: Identifying Battery
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Insert the new battery as shown.
Place the edge of the battery in the contacts first, then slide the battery back and down.

Fig 2: Inserting Battery
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Place the rubber gasket back on the remote control.
Make sure the gasket is seated properly.

Fig 3: Placing Rubber Gasket Back On Remote Control
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Place the back cover back on the top half of the remote control.
Place even pressure and listen for the halves to "snap" together.

Fig 4: Placing Back Cover Back On Remote Control
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002