Freeze Frame Data

HINT:

• Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) status as freeze frame data.
• The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to the on (IG) since the last time the ABS was activated.
• Freeze frame data at the time the ABS operates: The skid control ECU stores and updates data whenever the ABS system operates.

  When the skid control ECU stores data at the time a DTC is detected, the data stored during ABS operation is erased.

• Freeze frame data at the time a DTC is detected: When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

1. Connect Telecaster to the DLC3.
2. Turn the ignition switch on (IG).
3. Select "DTC INFO" on the tester display.
4. On the DTC data display screen, select the DTC data displayed with "*".

   ABS/VSC/TRAC: 

   REFERENCE VALUE CHART
   
   

   Tester Display	Measurement Item	Reference Value
   Stop Lamp SW	Stop light switch signal	Stop light switch ON: ON, OFF: OFF
   Operated System	Operated system	ABS operated: ABS, BA, SYS, NON
   Number of IG ON	Number of operations of ignition switch on (IG) after storing Freeze Frame Data	0 to 31
   Vehicle Speed	Vehicle speed reading	Min.: 0 mph (0 km/h), Max.: 202 mph (326 km/h)
   Vehicle Speed Grade	Vehicle speed grade	Min.: -25.11 m/s2 , Max.: 24.91 m/s2