Smart Alarm Function

* If any door is opened and then shut while the shift handle is in the P position and the power SW is in a state other than OFF, the certification ECU attempts to identify the electric key ID code within the passenger room twice. If the first attempt fails, the buzzer in combination meter sounds (Once) and the wireless door lock buzzer sounds (Three times), and the smart warning light in the combination meter lights up. If power supply is turned OFF via the power SW or the electrical key identification is confirmed on the second attempt, the warning stops.

* If all the doors are closed while the shift handle is in the P position and power SW is in a state other than OFF, then pushing the lock SW on any door handle activates the certification ECU to attempt to identify the location of the electric key inside and outside the passenger room. If the key is not detected inside the vehicle but is detected outside, then the wireless door lock buzzer will sound for two seconds and the doors will not lock.

* If the driver side door is opened and then shut while the shift handle is in a position other than P and the power SW is in a state other than OFF, the certification ECU attempts to identify the electric key ID code within the passenger room twice. If the first attempt fails, the buzzer in the combination meter and the wireless door lock buzzer will sound continuously. The smart warning light in the combination meter will light up as well. Then, if the shift handle is put into the P position or the electrical key identification is confirmed on the second attempt, then the alarm stops. If the driver turns the electric power OFF using the power SW or the electrical key identification is confirmed on the second attempt, then the smart warning light will go off.

* If doors other than the driver side door are opened and then shut while the shift handle is in a position other than P and the power SW is in a state other than OFF, the certification ECU attempts to identify the electric key ID code within the passenger room twice. If the first attempt fails, the buzzer in the combination meter will sound once and the wireless door lock buzzer will sound three times, and the smart warning light in the combination meter will light up. If the driver turns the electric power OFF using the power SW or the electrical key identification is confirmed on the second attempt, the warning will stop.

* If lock SW on the door handle is pushed when all the doors are shut and the power SW is in the OFF state, the certification ECU attempts to identify the electric key ID code within the passenger room twice. If the electric key is detected within the vehicle, then the wireless door lock buzzer sounds for two seconds and the doors will not be locked.

* If the power supply is turned OFF using the power SW after the "READY to drive" state has been maintained for about 20 minutes, the certification ECU attempts to identify the electric key ID code within the passenger room. If the ECU recognizes the code of a battery voltage decrease, the buzzer in the combination meter sounds once.

* If the power SW is pushed ON, then the certification ECU attempts to identify the electric key ID code within the passenger room twice. If the first attempt fails, the buzzer in the combination meter will sound once and the smart warning light will light up for about five seconds. Then, the driver's power SW operation attempt will be cancelled.