Charging Systems: Generator: Installation

INSTALL GENERATOR ASSEMBLY
1. Install the generator with the 3 bolts and nut.
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
  
  Fig 1: Locating Generator Bolts And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the generator connector.
3. Connect the generator wire with the nut.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
4. Install the terminal cap.
5. Install the harness bracket to the generator with the bolt.
  Torque: 31 N*m (316 kgf*cm, 23 ft.*lbf)
  
  Fig 2: Locating Generator Assembly Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT OIL COOLER PIPE ASSEMBLY (See INSTALLATION )
CONNECT VANE PUMP ASSEMBLY (See INSTALLATION )
INSTALL FRONT FENDER APRON SEAL FRONT RH (See INSTALLATION )
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
INSTALL NO. 1 ENGINE UNDER COVER SUBASSEMBLY (See INSTALLATION )
INSTALL FRONT FENDER SPLASH SHIELD SUBASSEMBLY LH (See INSTALLATION )
INSTALL FRONT FENDER SPLASH SHIELD SUBASSEMBLY RH (See INSTALLATION )
INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER HOSE ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL