September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Crankshaft Position Sensor: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- REMOVE ENGINE UNDER COVER RH
- REMOVE V-RIBBED BELT
(See
ON-VEHICLE INSPECTION
)
- REMOVE GENERATOR ASSEMBLY
(See
REMOVAL
)
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the crankshaft position sensor connector.
- Separate the crankshaft position sensor connector clamp and wire harness.
- Remove the bolt and crankshaft position sensor.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002