September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Steering Angle Sensor: Installation
- INSTALL STEERING ANGLE SENSOR
- Align the locating pins, attach the 6 claws and install the sensor to the spiral cable.
- INSPECT SPIRAL CABLE SUB-ASSEMBLY (See
INSPECTION
)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- INSTALL SPIRAL CABLE SUB-ASSEMBLY (See INSTALLATION
)
- INSTALL STEERING COLUMN COVER (See INSTALLATION
)
- INSTALL SPIRAL CABLE SUB-ASSEMBLY (See INSTALLATION
)
- INSTALL TILT LEVER BRACKET (See INSTALLATION
)
- INSPECT STEERING WHEEL CENTER POINT (See INSTALLATION
)
- INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION
)
- INSTALL STEERING PAD ASSEMBLY (See INSTALLATION
)
- INSPECT STEERING PAD ASSEMBLY
- Inspect the steering pad (see ON-VEHICLE INSPECTION
).
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see
INITIALIZATION
).
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- CHECK SRS WARNING LIGHT
- Check the SRS warning light (see
DIAGNOSIS SYSTEM
).