Front Speed Sensor: Installation

HINT:

Install the RH side by the same procedures with LH side.

1. INSTALL FRONT SPEED SENSOR LH 
   1. Install the speed sensor front LH with the bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      NOTE: Keep the tip of the front speed sensor LH.
      Fig 1: Locating Front Speed Sensor Bolt LH

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the sensor harness clamps with the 2 bolts A and B to the body and shock absorber.

      Torque: Bolt A 

      8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      Bolt B 

      19 N*m (192 kgf*cm, 14 ft.*lbf) 

      NOTE: Do not twist the sensor wire when installing the sensor.
   Fig 2: Locating Sensor Harness Clamp With Bolts
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Connect the clamp to the knuckle.
   4. Install the sensor harness and clamp to the body.
   5. Connect the speed sensor connector.
   Fig 3: Connecting Speed Sensor Connector
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL FRONT FENDER LINER LH 
3. REMOVE FRONT WHEEL 

   Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

4. CHECK ABS SPEED SENSOR SIGNAL 

   HINT:

   See TEST MODE PROCEDURE