Camshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CAMSHAFT POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
  
  Fig 1: Locating O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the camshaft position sensor with the bolt.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  NOTE: Make sure that the O-ring is not cracked or jammed when installing.
3. Connect the camshaft position sensor connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)

Fig 2: Locating Bolt And Camshaft Position Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002