LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> 4Runner Limited, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (1GR-FE) (Service Information) >> Knock Sensor >> Removal >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Knock Sensor: Removal: Removal

  1. REMOVE CYLINDER HEAD SUB-ASSEMBLY (for Bank 1) 
    1. Remove the cylinder head. Refer to REMOVAL .
  2. REMOVE NO. 1 WATER OUTLET PIPE 
    1. Detach the 3 wire harness clamps.
      Fig 1: Identifying No. 1 Water Outlet Pipe
      GTY212342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts, bolt and water outlet pipe.
  3. REMOVE KNOCK SENSOR 
    1. Disconnect the 2 sensor connectors.
      Fig 2: Identifying Knock Sensor Connectors & Knock Sensors With Bolts
      GTY191273Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and 2 sensors.
scientia non olet · About LEMON Manuals