LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> Sequoia Limited, 5.7 W >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control / Dynamic Control Systems (Service Information) >> Steering Angle Sensor >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Installation: Installation

  1. INSTALL STEERING ANGLE SENSOR 
    Fig 1: Aligning Pins On Spiral Cable With Installation Holes
    GTY124199Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Align the pins on the spiral cable with the installation holes on the steering sensor.
    2. Attach the 6 claws and install the spiral cable to the steering sensor.
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 1
  3. INSTALL UPPER STEERING COLUMN COVER  . Refer to INSTALLATION - Step 11
  4. INSTALL LOWER STEERING COLUMN COVER  . Refer to INSTALLATION - Step 12
  5. ADJUST SPIRAL CABLE  . Refer to INSTALLATION - Step 4
  6. INSTALL STEERING WHEEL ASSEMBLY  . Refer to INSTALLATION - Step 7
  7. INSTALL STEERING PAD  . Refer to INSTALLATION - Step 1
  8. INSTALL LOWER NO. 3 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 2
  9. INSTALL LOWER NO. 2 STEERING WHEEL COVER  . Refer to INSTALLATION - Step 3
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  11. INSPECT SRS WARNING LIGHT 
    1. Check the SRS warning light. Refer to DIAGNOSIS SYSTEM .
scientia non olet · About LEMON Manuals