LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2012 >> Matrix S, FWD, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (2AZ-FE) (Service Information) >> Integration Relay >> Removal >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Integration Relay: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE INTEGRATION NO. 2 RELAY 
    1. Remove the No. 1 relay block cover.
    2. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and then pull the integration relay out of the No. 1 relay block.
      Fig 1: Removing Integration Relay
      GTY194576Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the 3 connectors.
      Fig 2: Locating Connectors
      GTY183321Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals