LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Land Cruiser >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Control System (Service Information)) >> Accelerator Pedal >> On-Vehicle Inspection >> On-Vehicle Inspection
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

On-Vehicle Inspection

WARNING: This page is about a different car, the 2013 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ACCELERATOR PEDAL ROD ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. Read the value displayed on the Techstream.

      Standard Voltage

      Accelerator Pedal Operation Accel Sensor Out No. 1 Accel Sensor Out No. 2
      Released 0.5 to 1.1 V 1.2 to 2.0 V
      Depressed 2.6 to 4.5 V 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal, wire harness or ECM.

scientia non olet · About LEMON Manuals