LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Prius Two >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Smart Key System (For Start Function) (Diagnostics - Introduction) (Plug-In)) >> SMART KEY SYSTEM (for Start Function) >> Customize Parameters >> Customize Parameters
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters

WARNING: This page is about a different variant/trim than selected.
  1. CUSTOMIZE SMART KEY SYSTEM (for Start Function) 

    HINT: 

    The items in the table below can be customized.

    NOTE:
    • When the customer requests a change in a function, first make sure that the function can be customized.
    • Be sure to make a note of the current setting before customizing.
    • When troubleshooting a function, first make sure that the function is set to the default setting.
    1. Customizing with the Techstream
      1. Connect the Techstream to the DLC3.
      2. Turn the power switch on (IG).
      3. Turn the Techstream on.
      4. Enter the following menus: Customize Setting.
      5. Select the setting by referring to the table below.
        SMART KEY / ACCESS

        Tester Display Default Content Setting Relevant ECU
        Ignition Available Area All Function that switches the entry hybrid control system start detection area Front or All*1 Certification ECU (smart key ECU assembly)
        WARNING

        Tester Display Default Content Setting Relevant ECU
        Key Low Battery Warning ON Function that warns driver that the key battery is weak ON or OFF Certification ECU (smart key ECU assembly)
    2. Customizing with the multi-display (for Navigation Receiver Type)
      1. Turn the power switch on (IG).
      2. Enter the following menus: SETUP / Vehicle / Vehicle Customization / Door Lock Setting.
      3. Select the setting by referring to the table below.
        Display Default Content Setting Relevant ECU
        Key System with Elec. Key On Function that enables or disables the smart key system. On or Off Certification ECU (smart key ECU assembly)
    3. Customizing with the multi-display (for Radio and Display Type)
      1. Turn the power switch on (IG).
      2. Enter the following menus: SETUP / Vehicle.
      3. Select the setting by referring to the table below.
        Display Default Content Setting Relevant ECU
        Key System with Elec. Key On Function that enables or disables the smart key system. On or Off Certification ECU (smart key ECU assembly)
    4. Entry cancel function (manual operation).

      The electrical key cancel operation disables the following functions:

      • Entry Unlock/Lock
      • Entry Hybrid Control System Start
      • Entry System Back Door Open Function
      • Key Lock-in Prevention
      • Warning
      1. The operation procedure is as follows:

        Precondition:

        Power switch off, driver door closed and unlocked.

        1. Push the unlock switch of the key once.
        2. Open the driver door within 5 seconds.
        3. Push the unlock switch of the key twice within 5 seconds.
        4. Close and open the driver door twice within 30 seconds.

          (Driver door: Close → Open → Close → Open)

        5. Push the unlock switch of the key twice within 5 seconds.
        6. Close and open the driver door within 30 seconds.

          (Driver door: Close → Open)

        7. Close the driver door within 5 seconds.

          When electrical key cancel is activated, the wireless door lock buzzer sounds twice.

          To return to the original condition, perform the procedure again. When the original condition is returned, the wireless door lock buzzer sounds once.

scientia non olet · About LEMON Manuals