LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2017 >> 4Runner TRD Pro >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tire Pressure Sensor Registration

NOTE: When a tire pressure sensor and/or tire pressure monitor ECU are replaced, the transmitter ID needs to be registered in the tire pressure monitor ECU. To perform this procedure, a Toyota Techstream must be used.
NOTE: Before beginning registration process on vehicles where tire pressure sensors have not been replaced, retrieve sensor transmitter ID(s) using Techstream (under Data List) or by reading the ID on the tire pressure sensor. If sensor is being replaced with a new one, make a note of the 7-digit number (transmitter ID) before installation, as it cannot be seen after sensor is installed. See Figure.
  1. Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
  2. Ensure ignition switch is OFF.
  3. Connect Techstream to DLC3.
  4. Turn ignition switch ON.
  5. Turn Techstream ON.
  6. Perform the transmitter ID registration. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
    NOTE: If the ID registration step is not completed within 300 seconds, ID registration is canceled.
  7. Perform the procedure displayed on the Techstream
scientia non olet · About LEMON Manuals