September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Power Source Mode does not Change to ON (ACC) [09/2016 - ]: Procedure

CHECK FOR DTC

Using the Techstream, check for certification ECU (smart key ECU assembly) DTCs.

Body Electrical > Power Source Control > Trouble Codes

Body Electrical > Smart Key > Trouble Codes

Body Electrical > Starting Control > Trouble Codes

Result

Result	Proceed to
DTCs are not output	A
Smart key system (for Start Function) DTCs are output	B

Result:

B

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2016 - 05/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [05/2019 - ]

Result:

A

See step 2

CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
See step 3

Result

Proceed to

OK

NG

Result:

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

Result:

OK

See step 3
INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (ACC RELAY)
See step 4

Result

Proceed to

OK

NG

Result:

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY. Refer to REMOVAL [09/2016 - 07/2020] , or refer to REMOVAL [07/2020 - ]

Result:

OK

See step 4
CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
See step 5

Result

Proceed to

OK

NG

Result:

OK

USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2016 - 05/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [05/2019 - 07/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - 06/2021] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2021 - ]

Result:

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY). Refer to REMOVAL [09/2016 - 07/2020] , or refer to REMOVAL [07/2020 - ]