LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2021 >> Highlander LE, FWD >> Repair and Diagnosis (Single Page) >> Electrical >> Starter >> Stop And Start System Cancel Switch Assembly - Service Information >> Stop And Start System Cancel Switch Assembly >> Inspection [12/2019 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection [12/2019 - ]: Procedure

  1. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY (COMBINATION SWITCH ASSEMBLY) 
    1. Check the resistance.
      1. GTY854801Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Eco Run Cancel Switch Assembly (Combination Switch Assembly))

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        P7-5 (ECU) - P7-2 (GND) Eco run cancel switch assembly (combination switch assembly) being pushed and held Below 50 Ω
        Eco run cancel switch assembly (combination switch assembly) not pushed 10 kΩ or higher

        If the result is not as specified, replace the eco run cancel switch assembly (combination switch assembly).

    2. Check illumination.
      1. Apply battery voltage to the integration control and panel assembly and check that the switch illuminates.

        OK

        Condition Specified Condition
        Battery positive (+) → P7-6 (ILL+)
        Battery negative (-) →P7-1 (ILL-)        		 Illuminates
        GTY854803Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Eco Run Cancel Switch Assembly (Combination Switch Assembly))

        If the result is not as specified, replace the trail switch (combination switch assembly).

scientia non olet · About LEMON Manuals