Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch [11/2018 - ]: Procedure

1. Using the Techstream, read the data for the condition when the power window regulator switch assembly was operated.

   Refer to DATA LIST / ACTIVE TEST [11/2018 - 10/2023] , or refer to DATA LIST / ACTIVE TEST [10/2023 - 11/2024] , or refer to DATA LIST / ACTIVE TEST [11/2024 - ]

   Body Electrical > P-Door Motor > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   P Door P/W Auto SW	Front passenger door power window auto switch signal	OFF or ON	OFF: Front passenger door power window auto switch not being operated ON: Front passenger door power window auto switch being operated	-

   Body Electrical > P-Door Motor > Data List 

   Tester Display
   P Door P/W Auto SW

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  3

Result: 

OK 

See step  2

1. Initialize the front power window regulator motor assembly RH.

   Refer to INITIALIZATION [11/2018 - ]

   OK

   Power window system operates normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

Refer to REMOVAL [11/2018 - 02/2019] , or refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020] , or refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]

1. Remove the power window regulator switch assembly.

   Refer to REMOVAL [11/2018 - ]

2. Inspect the power window regulator switch assembly.

   Refer to INSPECTION [11/2018 - 12/2021] , or refer to INSPECTION [12/2021 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY 

Refer to REMOVAL [11/2018 - ]

Result: 

OK 

See step  4

1. Disconnect the I3 power window regulator switch assembly connector.
2. Disconnect the I7 front power window regulator motor assembly RH connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I3-8 (AUTO) - I7-4 (AUTO)	Always	Below 1 Ω
   I3-8 (AUTO) or I7-4 (AUTO) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 

Refer to REMOVAL [11/2018 - 02/2019] , or refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020] , or refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR