DTC P0606-09: Control Module Processor (Brake Override System Output Signal) Component Failure [12/2021 - ]: Procedure
- READ OUTPUT DTC (IN ADDITION TO DTC P0606-09)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Wait 1 second or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0606-09 is output A DTC P0606-09 and other DTCs are output B
Result:
A
REPLACE ECM. Refer to REMOVAL [08/2020 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
Result:
B
See step 2
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2021 - 10/2022]
, or Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2022 - 10/2023]
, or Refer to DIAGNOSTIC TROUBLE CODE CHART [10/2023 - 11/2024]
, Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2024 - ]
HINT:
After the inspection, perform the following procedure.
Result
Proceed to NEXT Result:
NEXT
See step 3
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTCs.
Powertrain > Engine > Clear DTCs
- Turn the ignition switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTCs are not output A DTC P0606-09 is output B
Result:
A
END
Result:
B
REPLACE ECM. Refer to REMOVAL [08/2020 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]