Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine stop and start ECU removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) | Stop and start system | Refer to PRECAUTION [11/2018 - 12/2021] |
| Perform steering sensor zero point calibration | Lane control system | Refer to INITIALIZATION [11/2018 - 12/2021] | |
| Parking support brake system* | |||
| Pre-collision system | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [11/2018 - 10/2022] | |
| Panoramic view monitor system | Refer to INITIALIZATION [11/2018 - 10/2022] | ||
| Reset back door close position | Power back door system | Refer to INITIALIZATION [11/2018 - 10/2023] | |
| Back door lock initialization | Power door lock control system | Refer to INITIALIZATION [11/2018 - ] |
*: When performing learning using the Techstream.