Display group 60 - Speed control - Electronic power control (EPC) system adaptation
| Display group 60 - Speed control - Electronic power control (EPC) system adaptation * See note | ||||||
|
||||||
|
||||||
| System in basic setting 60 | → | Indicated on display | ||||
| xxx % | xxx % | x | Text | |||
| 1 | 2 | 3 | 4 | Display zones | Specification | Evaluation |
| Adaptation status (ADP. runs / ADP. OK. / ADP ERROR) | ADP. OK. | --- | ||||
| Learning step counter | 0...8 | --- | ||||
| Throttle valve angle Angle sensor -2- for throttle drive G188 | 100...0 % | --- | ||||
| Throttle valve angle Angle sensor -1- for throttle drive G187 | 0...100 % | --- | ||||
* Erase learned values and adapt (match) Motronic Engine Control Module (ECM) J220 to Throttle Valve Control Module → Motronic Engine Control Module (ECM) J220 to Throttle Valve Control Module J338, matching .
NOTE:
- Note on display group 60:
- Adapting the Throttle Valve Control Module J338 is performed with ignition switched on.
- Motronic Engine Control Module (ECM) J220 is adapted to throttle valve control module when selecting display group 60 under function "04-Basic setting". This adaptation must always be carried out when another Throttle Valve Control Module J338 (or another complete engine) or another Motronic Engine Control Module (ECM) J220 is installed.
- The specifications indicated in display zones 1 and 2 do not fully reach the max. min. figures.
- The throttle valve angle sensors are opposed. The values from both angle sensors must always add up to approx. 100%.
- The counter counts from 0 to 8 in display zone 3 during the adaptation.