Display group 62 - Speed control - Electronic Power Control system

Display group 62 - Speed control - Electronic Power Control system
Ignition on, engine not running
Read measured value block 62			→	Indicated on display
xxx %	xxx %	xxx %	xxx %
1	2	3	4	Display zones	Specification	Evaluation
				Sender -2- for accelerator pedal position G185	4...49 %	---
			Throttle Position (TP) Sensor G79		12...97 %	---
		Throttle valve angle Angle sensor -2- for throttle drive G188			100...0 %	---
	Throttle valve angle Angle sensor -1- for throttle drive G187				0...100 %	---

NOTE:

Note on display group 62:
The angle sensors for the Throttle Valve Control Module and the Throttle Position (TP) sensor are featured in pairs for reasons of safety. The Motronic Engine Control Module (ECM) J220 constantly checks the plausibility of the potentiometers.
The value from Sender - 2 - for accelerator pedal position G185 must display approx. half the value of Throttle Position (TP) sensor 1 G79 at all times.
The angle sensors for throttle drive are opposed. The values from both angle sensors must always add up to approx. 100 %.