Control module identification: Notes
The control module version is displayed when the scan tool VAG1551, the vehicle system tester VAG1552 or the vehicle diagnostic, testing and information system VAS5051 is connected and Engine Control Module (ECM) selected → VAG1551 and Motronic Engine Control Module (ECM) J220, connecting and selecting .
Equipment
| Engine code | BDF | ||
| System designation | Motronic ME7.1.1 | ||
| Exhaust emissions fulfil | LEV * See note | ||
| On Board Diagnosis (OBD) | OBD II | ||
| Output Diagnostic Test Mode (DTM) | yes | ||
| Method of data transfer to VAG1551 /1552 | Rapid data transfer | ||
| DTC memory | Non-volatile memory * See note | ||
| Memory for learned values | Volatile memory * See note | ||
*LEV = Low Emission Vehicles (exhaust emissions max. 0.075 g/mi HC).
*Independent of voltage supply.
*All values are erased when voltage supply is interrupted.
| Engine code | BDF | ||
| Oxygen Sensor control | 2 sensors | ||
| Knock control | 2 knock sensors | ||
| Three Way Catalytic Converter (TWC) | yes | ||
| Exhaust gas recirculation | no | ||
| Charging | no | ||
| Secondary air system | yes | ||
| Electronic Power Control | yes | ||
| Variable intake manifold | yes | ||
| Variable valve timing | yes * See note | ||
*Two independently variable camshafts.