Transmission Control Module (TCM) J217 replacing, 4 Spd. Automatic Transmission 01M
NOTE:
- To achieve optimal anti-theft protection for the vehicle, an anti-theft immobilizer was installed. The anti-theft immobilizer is a system for enabling/locking the Transmission Control Module (TCM) J217.
- To perform adaptation of the anti-theft immobilizer. Refer to the Ebahn website.
Procedure
Check the identification of the previous Transmission Control Module (TCM) J217 as follows:
- Connect the scan tool.
- Switch the ignition on.
- Select "Diagnostic mode 9: Vehicle information."
- Select the "Test-ID 04: Calibration identification".
- The Transmission Control Module (TCM) J217 identification will be displayed, e.g.: 09G27750 L 0301
- End diagnosis and switch the ignition off.
Removal
- Remove the wiper arms and wind cowl.
- Disconnect the electrical harness connector in the direction of the arrow.
- Remove the mounting bolts - arrows -
Installation
- Installation is performed in the reverse order of removal. note the following:
- Check the identification of the new Transmission Control Module (TCM) J217 to ensure it matches the old Transmission Control Module (TCM) J217.
- Code the Transmission Control Module (TCM) J217.
Final procedures
- Check the DTC memory.
- If necessary, erase DTC memory of the Transmission Control Module (TCM) J217..
- If the DTC memory was erased, generate readiness code.
End diagnosis