Test requirements
- The fuses must be OK.NOTE: Fuse holder is located behind access panel at far left end of dash.
- The battery voltage must be at least 11.5 V.
- All electrical accessories, e.g. lights and rear window defroster must be switched off.
- If the vehicle is equipped with air conditioning, it must be turned off.
- Selector lever must be in position "P" or "N" on vehicles with an automatic transmission.
- Knock sensor malfunction detected by On Board Diagnostic (OBD). See DTC MEMORY .
- The signal from brake light switch and brake pedal switch must be OK, Checking. See BRAKE LIGHT SWITCH -F- AND BRAKE PEDAL SWITCH (CRUISE CONTROL/DIESEL DIRECT FUEL INJECTION) -F47- SIGNAL, CHECKING .
- Engine Coolant Temperature (ECT) must be at least 85 °C, display group 28, display zone 3.