Test-ID 166 ($A6): Misfire Cylinder 5 Data
-- Connect the scan tool.
-- Start the engine and let run at idle speed.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored ".
Select "Test-ID 166 ($A6)".
-- Select the desired "Test-ID (TID)" or "Hex-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min./Max. Values | Additional Information | |
|---|---|---|---|---|---|
| 11 ($0B) | P0305 | Combustion misfires Cylinder 5 Average value over 10 Driving Cycles. For additional information, refer to the Bosch Motronic ME 7 OBD System Strategy. Page 11. | 0 - 65535 (counts) | Refer to DTC P0305 in the DTC table SAE P0XXX DIAGNOSTIC TROUBLE CODES . | |
| 12 ($0C) | P0305 | Combustion misfires Cylinder 5 in this Driving Cycle. For additional information, refer to the Bosch Motronic ME 7 OBD System Strategy. Page 11. | 0 - 65535 (counts) | Refer to DTC P0305 in the DTC table SAE P0XXX DIAGNOSTIC TROUBLE CODES . | |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure.
-- Switch the ignition off.
-- End of diagnosis.