Test-ID 61 (3D): Purge Flow Monitor
-- Connect the scan tool.
-- Start the engine and let run at idle speed.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored ".
Select "Test-ID 61 ($3D)".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 128 ($80) | P0441 | Function Check. For additional information, refer to the Bosch Motronic ME 7 OBD System Strategy. Page 17. | 0.25 | 2 | Refer to DTC P0441 in the DTC table SAE P0XXX DIAGNOSTIC TROUBLE CODES . |
| 130 ($82) | - | Function Check. For additional information, refer to the Bosch Motronic ME 7 OBD System Strategy. Page 17. | 0.07 | -0.07 | - |
| 131 ($83) | - | Function Check. For additional information, refer to the Bosch Motronic ME 7 OBD System Strategy. Page 17. | 0.15 | 1 | - |
| 133 ($85) | P0441 | Tank ventilation valve check off % DTEV: Active test Air balance at idle. For additional information, refer to the Bosch Motronic ME 7 OBD System Strategy. Page 17. | 0 ms | 1300 ms | Refer to DTC P0441 in the DTC table SAE P0XXX DIAGNOSTIC TROUBLE CODES . |
-- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure.
-- Switch the ignition off.
-- End of diagnosis.