Check Control Module Version
- Connecting scan tool. Refer to Scan tool, connecting . Initiating On Board Diagnostic (OBD). Refer to Convenience system, initiating On Board Diagnostic (OBD) .
- Switch on ignition.
- Press button -1- for "Rapid data transfer" mode.
- Switch on printer with Print button (warning lamp in button lights up).
- Press buttons -0- and -1-.
Indicated on display:
| Rapid data transfer Q 01-Check Control Module Version |
- Confirm entry with the -Q- button.
The control module identification will be shown on the V.A.G 1551 scan tool display, e.g.:
| 1C0962258 XX Cent. Lock. 0001 → Coding XXXXX WSC XXXXX |
Breakdown of the display:
|
Part No. of control module system designation(XX2) Cent. Locking 0001) |
|
Code number (dealer code number)1) |
1)- Will be automatically stored in the control module when entering the system.
2) A number or number/letter combination (03 or 6Q, or others) indicate a correct programming of the control module.
- Press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
NOTE:
- If one of the malfunction messages opposite appears in the display, the possible causes of the malfunction can be printed out with the HELP button.
- Ignition must be switched on.
- Malfunctions have occurred at the start of or during the program (external interference?).
- Check diagnosis wires as well as voltage supply and Ground connection.
- Press buttons -0- and -6- to end the output.
Indicated on display:
| Rapid data transfer Q 06 End output |
- Confirm entry with the -Q- button.
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Switch off ignition.
- Disconnect connector to V.A.G 1551 scan tool.