Checking wires to Engine Control Module (ECM)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Connect test box to control module wiring harness. Refer to Test box, connecting for wiring test
Knock Sensor (KS) 1 -G61-
- Check wires between test box and 3-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ω
| Component | Connector | Test box |
| Knock Sensor (KS) 1 -G61- | Terminal 1 | Socket 106 |
| Terminal 2 | Socket 99 | |
| Terminal 3 | Socket 108 |
- Also check wires for short circuit to each other.
Specified value: ∞ Ω
Knock Sensor (KS) 2 -G66-
- Check wires between test box and 2-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ω
| Component | Connector | Test box |
| Knock Sensor (KS) 2 -G66- | Terminal 1 | Socket 107 |
| Terminal 2 | Socket 99 |
- Also check wires for short circuit to each other.
Specified value: ∞ Ω
If no malfunctions are found in wires:
- Replace the respective knock sensor:
- Knock Sensor (KS) 1 -G61-. Refer to Parts of ignition (vehicles with engine codes BDF and BJS), removing and installing , item 7
- Knock Sensor (KS) 2 -G66-. Refer to Parts of ignition (vehicles with engine codes BDF and BJS), removing and installing , item 17
- Erase DTC memory of Engine Control Module (ECM). Refer to Diagnostic mode 4: Reset/erase diagnostic data
- Generate readiness code. Refer to Readiness code, generating