Test-ID 60 (3C): EVAP Monitor (0.020)
-- Connect the scan tool.
-- Start the engine and let run at idle speed.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored ".
Select "Test-ID 60 ($3C)".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 129 ($81) | P0456 | Fuel Tank Leak Test (Pinhole leak). For additional information, refer to the Bosch Motronic ME 7.1.1 OBD System Strategy. | 6500 ms | 65535 ms | Refer to DTC P0456 in the SAE P0XXX DIAGNOSTIC TROUBLE CODES . |
| 130 ($82) | - | Tank leak test after initial flush (Pressure release through initial flush, i.e. tank vent phase) Reed contact closed during initial flush Tank does not leak (can only be checked when OK. For additional information, refer to the Bosch Motronic ME 7.1.1 OBD System Strategy. | 11400 ms | 65535 ms | - |
-- If any of components or systems fail to meet the specified values. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY to check for stored DTC's or the corresponding diagnostic repair procedure.
-- Switch the ignition off.
End of Diagnosis