ABS Control Module -J104-, SEPARATING FROM THE ABS Hydraulic Unit -N55-, MARK 70 ABS/ASR

Removing 

-- Get the coding from the ABS Control Module -J104- and write it down.

Use the Vehicle Diagnostic Tester.

• Chassis 
• Brake System 
• Anti-lock braking system ABS/ASR Mark 70 
• Function 
• Check coding in the ABS control module J104 

Remove the ABS Hydraulic Unit -N55- and ABS Control Module -J104-, refer to ABS Control Module -J104- AND ABS Hydraulic Unit -N55-, WITH ABS MARK 70 ABS/ASR .

Install the transportation protection for the valve domes on the ABS Control Module -J104- after separating the ABS Hydraulic Unit -N55- from the ABS Hydraulic Unit -N55-.

The warranty on the ABS Hydraulic Unit -N55- will not be honored if the transportation protection is missing.

1. Transport protection for valve domes (foam)
2. M10 plug
3. M12 plug

-- Place the ABS Hydraulic Unit -N55- and the ABS Control Module -J104- on a clean level surface facing upward.

-- Remove bolts -arrows-.

-- Remove the ABS Control Module -J104- from the ABS Hydraulic Unit -N55- in -direction of arrow- without tilting it.

-- Carefully remove all the seals from the valve domes on the ABS Hydraulic Unit -N55-.

-- Cover ABS Control Module -J104- solenoid coils with a lint-free cloth.

After disconnecting from ABS Control Module -J104- and ABS Hydraulic Unit -N55-, use transportation protection for valve body.

Installing, refer to ABS Control Module -J104-, ATTACHING TO ABS Hydraulic Unit -N55-, MARK 70 ABS/ASR .