Monitor-ID $85: Boost Pressure Control Loop
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID 85".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $C3 | P00AF | Boost Pressure Slow Response | 0.00 % | 100.01 % | Refer to DTC P00AF in the DTC summary table. |
| $CC | P026A | Charger under cooling | -3276.8 °C | 3276.7 °C | Refer to DTC P026A in the DTC summary table. |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.