LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2013 >> Passat TDI SE, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (3.6L - Generic Scan Tool - Engine Code: CDVB (1 Of 2)) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 09 >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions 2013-2014 >> Monitor-ID $A5: Misfire Cylinder 4 Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor-ID $A5: Misfire Cylinder 4 Data

WARNING: This page is about a different variant/trim than selected.

-- Connect the scan tool.

-- Start the engine and let run at idle speed.

-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored".

Select "Monitor-ID $A5".

-- Select the desired "Test-ID" or "Hex-ID".

-- Check specified values at idle.

Test-ID DTC Component or System Min. Max. Additional Information
$0B P0304 Cylinder 4 data averaged during last 10 drive cycles. 0.00 63535 Refer to DTC P0304 in the DTC table Engine Control Module -- 2013-2014 MY => P0304
$0C P0304 Cylinder 4 data current driving cycle. 0.00 63535 Refer to DTC P0304 in the DTC table Engine Control Module -- 2013-2014 MY => P0304

-- If any of components or systems fail to meet the specified values. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY  to check for stored DTC's or the corresponding diagnostic repair procedure.

-- Switch the ignition OFF.

scientia non olet · About LEMON Manuals