Monitor-ID $A3: Misfire Cylinder 2 Data
WARNING: This page is about a different variant/trim than selected.
-- Connect the scan tool.
-- Start the engine and let run at idle speed.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored".
Select "Monitor-ID $A3".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $0B | P0302 | Cylinder 2 data averaged during last 10 drive cycles. | 0.00 | 63535.0 | Refer to DTC P0302 in the DTC table Engine Control Module -- 2015 MY => P0302 |
| $0C | P0302 | Cylinder 2 data current driving cycle. | 0.00 | 63535.0 | Refer to DTC P0302 in the DTC table Engine Control Module -- 2015 MY => P0302 |
-- If any of components or systems fail to meet the specified values. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY to check for stored DTC's or the corresponding diagnostic repair procedure.
-- Switch the ignition OFF.