Monitor-ID $3D: Tank Vent Valve function check
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check test the results of components that are not continuously monitored".
Select "Monitor-ID $3D".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0441 | Purge Flow Monitor | 0.300 | 1.999 | Refer to DTC P0441 in the DTC table Engine Control Module --, 2012-2014 MY => P0441 |
| $84 | Pass only | EVAP purge valve OK by initial purge. | 50 | 65535 | Test: Pass only |
| $85 | Pass only | EVAP purge valve OK by leak check. | 0.0 Sec. | 1.2 Sec. | Test: Pass only |
| $88 | Pass only | Purge flow OK by lambda deviation counter. | 2.000 | 65535 | Test: Pass only |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition Off.