Monitor-ID $A5: Misfire Cylinder 4 Data
-- Connect the scan tool.
-- Start the engine and let run at idle.
-- Select "Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored".
Select "Monitor-ID $A5".
-- Select the desired "Test-ID" or "Hex-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
| $0B | P0304 | Cylinder 4 data averaged during last 10 drive cycles. | 0.000 | 65535 | Refer to DTC P0304 in the DTC table Engine Control Module --, 2015 MY => |
| $0C | P0304 | Cylinder 4 data current driving cycle. | 0.000 | 65535 | Refer to DTC P0304 in the DTC table Engine Control Module --, 2015 MY => |
-- If any of components or systems fail to meet the specified values. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY to check for stored DTC's or the corresponding diagnostic repair procedure.
-- Switch the ignition Off.