Abs Control Module -J104- And Abs Hydraulic Unit -N55-, Removing And Installing, With A Gasoline Engine: Installing

Install in reverse order of removal. Note the following:

NOTE:

Remove the plugs on the new ABS Hydraulic Unit -N55- only when installing the corresponding brake line.

Brake fluid may leak out if the plugs are removed from the ABS Hydraulic Unit -N55- beforehand and the unit may not be sufficiently filled or adequately bled.

When installing the hydraulic unit, make sure the damper rubber is not pushed out of the bracket.

-- Install the brake lines carefully with the :VAG1410/8 .

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- Code the ABS Control Module -J104-. Refer to Vehicle Diagnostic Tester.

While doing so, a basic setting for the Steering Angle Sensor -G85-, Transverse Acceleration Sensor -G200-, Longitudinal Acceleration Sensor -G251- and Brake Pressure Sensor 1 -G201- must be performed.