Steering Column, Removing And Installing, RHD: Installing
-- Install the steering column -1- with the opening into the guide -arrow-.
Only in this way is the correct installation position of steering column to mounting bracket guaranteed.
Always follow the bolt installation sequence when installing the steering column.
-- Secure the steering column with the bolt -1-.
-- Install the brake pedal crash bolster -2- and secure it with the bolt -1-.
Vehicles With DSG Transmission And Automatic Transmission
-- Secure the steering column with the bolt -1-.
Vehicles With Manual Transmission
-- Install the clutch pedal crash bolster -2- and secure it with the bolt -1-.
For All Vehicles
-- Tighten The Bolts -1-, -2-, -3- And -4- One After The Other To The Tightening Specification .
-- Install the cable guide -1- under the steering column.
Tabs -arrow- must engage into guide on both sides.
-- Attach the ground cable to the steering column -arrow-.
-- Install the universal joint -2- on the steering gear pinion gear and tighten the bolt -1-.
-- Insert the footwell trim panel -3- and push it downward opposite direction of -arrow-.
-- Attach the nut -1-.
-- Insert the entire clip -2- and press the pin all the way in.
Vehicles With Ignition Switch
-- Connect the connector -1-.
Vehicle With "Keyless Access" Keyless Locking And Starting System
-- Connect the connector -1-.
-- Clip the wire into the retainer on the Electronic Steering Column Lock Control Module -J764- -arrow-.
For All Vehicles
-- Install the footwell air duct. Refer to A/C COMPRESSOR .
-- Install the trim -1-.
-- Insert the connector -2- until it audibly engages.
-- Attach the trim panel -1- with bolts -arrows-.
-- Refer to A/C COMPRESSOR .
-- Install the steering column trim. Refer to STORAGE COMPARTMENTS AND COVERS .
-- Install the steering wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
-- Install the driver side airbag unit. Refer to DRIVER SIDE AIRBAG .
-- Perform a basic setting on the Steering Angle Sensor -G85- using the Vehicle Diagnostic Tester.