Electromechanical Steering Gear Boot, Removing And Installing: Installing

-- Turn steering wheel into straight ahead position.

-- Guide new clamp and boot onto tie rod.

-- Slightly grease the sealing surface of the bellow to the tie rod with Grease :G 052 168 A1  (from the repair kit, from Fuchs Renolit JP1619).

-- Slide the boot -2- onto the tie rod -1- as illustrated.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure spring clamp on boot using :VAG1275A  .

-- Slightly grease the sealing surface of the bellow to the steering gear housing with Grease :G 052 168 A1  (from the repair kit, from Fuchs Renolit JP1619).

-- Push the boot all the way onto the steering gear housing.

-- Tighten New Clamp Using :VAS6199 To The Extent Depicted In The Illustration  .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the tie rod end up to the marking made earlier during the removal. Refer to TIE ROD END, REMOVING AND INSTALLING .

-- Install the front wheel and tighten the bolts. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Perform vehicle alignment. Refer to VEHICLE ALIGNMENT .

-- If both tie rods were replaced, then the basic setting for the Steering Angle Sensor -G85- must be performed using the Vehicle Diagnostic Tester.

-- Then perform the basic setting to the steering using the Vehicle Diagnostic Tester.