| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
.
-- Was Complaint verified? |
-- YES:
-- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- DISCONNECT: Fuel Pressure Sensor -G247- harness connector.
- IGNITION: ON.
- CHECK: Fuel Pressure Sensor -G247- harness connector terminals 1 to 3 for voltage.
- SPECIFIED VALUE: About 5.0 V.
- IGNITION: OFF.
-- Was Value obtained? |
-- YES:
-- NO:
|
| 3 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate repair information.
- CHECK: Fuel Pressure Sensor -G247- harness connector terminal 2 to the Engine Control Module - J623- harness connector T60 / 25 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Was Value obtained? |
-- YES:
- REPLACE: Fuel Pressure Sensor -G247-. Refer to appropriate repair information.
- GO TO: Step 5.
-- NO:
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 5.
|
| 4 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate repair information.
- CHECK: Fuel Pressure Sensor -G247- harness connector terminal 1 to the Engine Control Module - J623- harness connector T60 / 14 for resistance.
- CHECK: Fuel Pressure Sensor -G247- harness connector terminal 3 to the Engine Control Module - J623- harness connector T60 / 26 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained? |
-- YES:
- REPLACE Engine Control Module -J623-. Refer to appropriate repair information.
- GO TO: Step 5.
-- NO:
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 5.
|
| 5 |
- Final Procedure
- Perform a road test to verify repair.
- Do any DTC's return:
|
-- YES:
-- NO:
- Repair is complete. Generate readiness code. Refer to READINESS CODE
.
- Return vehicle to Customer.
|