Monitor-ID $3C: Fuel Tank EVAP System Integrity/Leak Test (0.20/0.5mm)
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Monitor-ID 3C".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $81 | P0456 | Tank leak test: Pinhole leak (0.5 mm). | 4.50...6.00 Sec. | 65.535 Sec | Refer to DTC P0456 in the DTC summary table.Engine Control Module --, 2015 MY |
| $82 | --- | Evap system monitor OK by initial Purge Test | 12.10 g | 6553.5 g | Pass only. |
-- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.