Control Module, Installing On Hydraulic Unit: Notes
Special tools and workshop equipment required
- ESD Work Surface:VAS6613
- Torque Screwdriver:VAG1624
- TORX® insert T25
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- TORX® Bolts - Control Module
Excessive shaking (for example, dropping, impact) may destroy the control module. The control module must then no longer be used.
- Surfaces must be cleaned before assembling.
-- Place the control module on the hydraulic unit without tilting.
-- Install the hydraulic unit and control module with the new inner TORX® bolts switching back and forth in two steps according to the tightening specification.
The hydraulic unit threads cannot be re-cut to secure the control module. In the threads are damaged (bolts are difficult to install by hand or the bolts cannot be tightened to the tightening specification). The hydraulic unit must be replaced.