Windshield Projection Head Up Display Control Module -J898-, REMOVING AND INSTALLING: Installing
Install in the reverse order of removal while noting the following:
If the windshield projection control module is replaced.
-- For new parts, remove the bolts -2-.
-- Remove the adjusting element plates -3- from the windshield projection control module -1-.
Continuation for all vehicles
Risk of destroying the windshield projection control module.
- When inserting, never apply pressure on the housing upper section.
- A windshield projection control module that has been dropped needs to be replaced.
-- Insert the windshield projection control module -1-.
-- Connect the connectors.
-- Tighten the bolts -arrows-.
-- Place the windshield and secure with adhesive tape, but do not bond.
-- Switch the ignition on.
-- Perform a function test.
-- Install the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .
-- Calibrate the windshield projection control module. Refer to Windshield Projection Head Up Display Control ModuleJ898, Calibrating .