Overview - Control Module And Hydraulic Unit

• Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, GASOLINE ENGINE .

• Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING, GASOLINE ENGINE .

• Tighten the new TORX^® bolts in two steps, switching back and forth.
• 1. Step: preliminary tightening specification: 1 Nm to 1.5 Nm (to position the seal)
• 2. Step: final tightening specification: 2.5 Nm

• 14 Nm
• To the right rear brake caliper
• Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread

• 14 Nm
• To the left front brake caliper
• Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread

• 14 Nm
• To the right front brake caliper
• Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread

• 14 Nm
• To the left rear brake caliper
• Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread

• 14 Nm
• Brake master cylinder/primary piston circuit to the ABS Hydraulic Unit -N55-
• Identification: 6 mm diameter and pipe fitting with a M12 x 1 thread

• 14 Nm
• Brake master cylinder/secondary piston circuit to the ABS Hydraulic Unit -N55-
• Identification: 6 mm diameter and pipe fitting with a M12 x 1 thread

• Removing and Installing

• 8 Nm

Allocation. Refer to the Parts Information.

• 20 Nm

• 20 Nm