Monitor-ID $3D: EVAP Purge Valve Function Check
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored".
Select "Monitor-ID $3D".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $8C | P0496 | Purge Valve Open Check. | 0.0 mA | 4.2 - 14.0 mA | Refer to DTC P0496 in the DTC summary table.Engine/Motor Control Module --, 2020 MY => P0496 |
| $8D | P0441 | Purge Valve Close Check. | 0.0 mA | 4.0 - 36.5 mA | Refer to DTC P0441 in the DTC summary table.Engine/Motor Control Module --, 2020 MY => P0441 |
| $8E | P04F0 | High Pressure Purge Line. | 0.0 mA | 4.1 - 36.5 mA | Refer to DTC P04F0 in the DTC summary table.Engine/Motor Control Module --, 2020 MY => P04F0 |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.