Monitor-ID $3D: EVAP Purge Valve Function Check
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 06: Check / test the results of components that are not continuously monitored".
Select "Monitor-ID $3D".
-- Select the desired "Test-ID".
-- Check specified values at idle.
| Test-ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $8C | P0496 | CPV Diagnosis With DMTL Stuck Open. | 0.0 mA | 4.204 - 13.996 mA | Refer to DTC P0496 in the DTC summary table.Engine Control Module -- => P0496 |
| $8D | P0441 | CPV Diagnosis With DMTL Stuck Closed. | 0.0 mA | 4.003 - 35.998 mA | Refer to DTC P0441 in the DTC summary table.Engine Control Module -- => P0441 |
| $8E | P04F0 | CPV Diagnosis With DMTL High Pressure Purge Line. | 0.0 mA | 4.003 - 36.450 mA | Refer to DTC P04F0 in the DTC summary table.Engine Control Module -- => P04F0 |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.