New Control Module

Programming of alarm control module is performed using scan tool. New control modules are delivered with DTC GLA 113: Control Module Not Programmed. The alarm and courtesy light will not function. The control module must be programmed specifically for the vehicle that the module is being installed in. Three vehicle specific PIN codes are needed, and can be obtained through a Volvo dealership. Before removing old control module, use scan tool to read and record values. See VADIS car communications under Reading Off Programmed Values. Program this data back into NEW control module.

The first PIN code is needed to enable control module to program remote controls. The second PIN code is used to select lock type. The third PIN code is needed to activate components and select functions.